Snap-fit Skirting Duct Lid

Catalogue No: CML 200/50

Size: 200 x 50 mm

Cover: "Snap-Fit" Aluminium, Engages at top

Outlets: Standard Size " Centre Mount"

Suitable for: Category 6 Cabling

Stock Colours: APO Grey, Satin Black, Pearl White, Stone Beige, Natural Anodised

• Based on the "Centre Mount" range the "Snap Fit" system utilises an extruded aluminium cover which "Snap-Fits" into position to provide extra protection and streamline appearance.

• Ideally suited for use in schools, colleges and universities.

• Suitable for Category 6 data cabling.

• The ECD "Snap-fit" system eliminates the need to screw fix covers and can be mounted horizontally or vertically.

• The "Snap-fit" covers engage at the top edge of the duct, avoiding the problem of floor coverings obstructing the fitting or removal of the cover.

• Duct and covers are powder coat finished.

• Standard colours are Black, White, APO Grey and Stone Beige. Over 50 non-standard colours are available.

• This product has been examined in accordance with AS 3000 and conforms to A.C.A requirements.

Suggested Specification:

• The contractor shall allow to supply and install "Electric Cable Duct Systems P/L" CML 150/50 “Centre Mount” skirting duct (150mmx50mm) surface mounted or as otherwise nominated and as described below.

• The system will reflect the integrated voice/data cabling requirements of Category 5E and have ferrous mounting shrouds for both power and voice /data outlets. Outlets shall be standard size Clipsal, HPM or PDL Type.

• The body of the duct shall be extruded aluminium pre treated and powder coated to a standard colour (White, APO Grey, Stone Beige, or Black) or as nominated by the architect. The duct cover shall be pre-treated electro-galvanised steel, powder coated to match.

• The system shall be earthed in accordance with AS3000 wiring rules and conform to A.C.A requirements.

• Bends shall be site mitred to fine tolerances with concealed reinforcing angles riveted in position or alternatively manufactured internal / external bends . Adjacent lengths of duct body shall be splice joined with slide in joiner plates. Slide in stop ends shall be fitted where necessary.

• Installation shall be performed by experienced duct installers, generally as described on E.C.D “Recommended Installation Procedure” leaflet.

Parts List

Description	Part No	Colour
Duct Body - 3m lengths	CML 200/50	Nominate colour
Duct Cover - 3m lengths	CML 200 C	Nominate colour
GPO Mounting Kit only (no GPO)	CML 200/50 K	Nominate colour
Voice/Data Mounting Kit only (no bakelite supplied)	CML 200/50 VDK	Nominate colour
Internal Bend	CML 200/50 IB	Nominate colour
External Bend	CML 200/50 EB	Nominate colour
Reinforcing Angle (Site mitred bends)	CML 200 RA	n/a
Stop End	CML 200/50 SE	Nominate colour
Flat Bend Plate	CML 200 FB	n/a
Riser To Skirting Tee	CML 200/50 RT	Nominate colour
Angled Data Face Plate	VDCAT 6	Nominate colour